![]() specified does not exist in this user accountor) at 17:40:16 yesterday when I deliberately set an incorrect password in the home hub.ġ2:27:45, 17 Apr. Note that I saw the error you're getting (hostname. ![]() On the home hub I typically use the "username" login, but I've also just tested this with my email address login, and again successful.īelow is the log of my connection attempts. domain as a test in case it was an issue with that specific domain. domain and I've just now added a host in the. Here's a screen shot of my setup so you can check against a working setup. The log in also seems to work with both.Īny further thoughts would be appreciated! I am half a click away from the Draytek.! Is this "username" or the account email address? I have tried both and neither work. There is a question in my mind about the Username: field in the HH5 DDNS set up page. I use IE and Chrome - the result is the same - can I ask which browser you use. Can I ask which hostname extension you have used? I have tried single and three hostnames.Īs you see I am using a free no-ip ddns extension of. If I enter three hostnames the error is listed three times, once for each hostname. The event log has consistently recorded: "DDNS Status: error (the hostname specified does not exist in this user accountor is not in the service specified in the system parameter" When I then hit "Refresh" the "Dynamic DNS service status" changes to " Connection error - Execution error." The page behaviour is that after entering the DDNS host account information, the "Dynamic DNS service status" is " Connecting". The Advanced Settings>Broadband>Dynamic DNS page returns " Changes Applied" when I hit "Apply". The DDNS service is currently working fine using credentials on a PC with the No-IP User Client. This is usually installed by default on most Linux and BSD distros, but if not use your package manager to install it.I am reassured that your system works and have been around my settings again with same result. This script has one dependency, which is wget. The script can be run as a single instance with command line parameters, as a daemon, using crontabs (a utility for running programs on a schedule) or as a Linux service. I'm running Ubuntu server so I'm using apt and nano, but this should work on anything POSIX based such as Mac OS X, BSD, any flavor of Linux - even the Raspberry Pi. Here is my how-to guide and documentation for setting this up. There was no output to the console or to a log file either to diagnose the problem that I could find, so I decided to go about writing my own, which really wasn't that hard to do using a bash script and a few simple utilities on my Linux box. I downloaded the source and compile it following the instructions, and it appeared to be running, but it never updated my IP address. Many routers have a built in NO-IP client, but my router doesn't support NO-IP, and for whatever reason, I could never get the client that NO-IP recommended for a Linux host to work. NO-IP then associates that IP with the domain name so services can be setup against the domain rather than the IP that changes. Dynamic DNS allows a domain name (i.e ) to use a dynamic IP by updating NO-IP with a new IP address when the IP address changes. Typically, a domain name requires a static IP address to work. Most home and small office connections to the Internet have a dynamic IP, which means the IP addresses changes most every time the connection from the router is established. For those less familiar with NO-IP, it is a free dynamic DNS service. I'm probably not the first one to do this, but I had a need to use NO-IP's dynamic DNS service so I could easily configure devices and computers to access resources on my LAN when I'm away.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |